China High speed press

As an important metal processing equipment, the normal operation of China high speed press is not only related to production efficiency, but also to the safety of operators. Therefore, before starting the high speed press, a series of checks must be carried out to ensure the normal operation of the equipment and the safety of the operators.
Firstly, it is necessary to inspect the electrical system of the high speed press. Confirm that the electrical circuit is well grounded and the insulation resistance meets the standard requirements.

Secondly, check the lubrication system of the high speed press. Ensure that the lubricating oil level is normal, the oil is clean, and check the oil circuit to prevent blockage.

Next, it is necessary to inspect the mechanical parts of the high speed press. Check the clutch, gears, drive belts, nuts, and other components to ensure that they are not loose, worn, or otherwise abnormal.
At the same time, it is necessary to check the safety protection devices. Confirm that the safety protection door, emergency stop switch, dual hand operation button and other devices are intact and functioning properly. If any problems are found, damaged parts should be repaired or replaced in a timely manner.
Afterwards, conduct a no-load trial run of the high speed press. Before starting formal production, conducting a no-load trial run can verify the operating status and effectiveness of the high speed press.
Through these inspections, the occurrence of high-speed punch accidents can be greatly reduced, ensuring the smooth progress of the production process. Therefore, the inspection work before starting the high speed press is essential, as it is an important link to ensure the normal operation of the punch press and the safety of personnel.